PCC version v2.3.741.0
[This version of PCC was updated on 20 November 2013]
Download Release Notes here.
This installer will install PCC version v2.3.741.0. Before running this installer, you might want to make a backup of your Phantom folder. Please provide feedback via the PCC forum in the Phantom Zone at www.visionresearch.com/PhantomZone.
There are user guides and thorough software documentation available. Just navigate to the “Help” menu section to get started.
We recommend that the computer you use have a Pentium class microprocessor running 1.7 GHz or higher. The software will install on the following operating systems:
We also recommend you have 4GB of memory and at least 80GB of disk space.
Warning: For certain aspects of the new Signals Graph windows to work you must have OpenGL version 1.1 or greater installed on the PC.
Warning: This version of software has only been tested with the firmware versions shown in the table below. It will work with these or later versions. If your camera model does not appear below, it has not been tested with v2.3.741.0. You're more than welcome to download the software as it will not damage the camera however please do make sure you can fully acquire, download and playback a test cine using the acquisition parameters you are going to use before you perform an actual test.
Warning: If you are upgrading from version 663 or lower, Vision Research recommends that you run the Window Uninstall application prior to installing PCC 2.3.741.0
To check the firmware version of a camera, run your existing version of the Phantom software, connect to and select the camera of interest, go to "Help --> About" in the Phantom software. If your camera does not meet the minimum firmware requirements and you would like a firmware upgrade, please contact VRI Technical Support.
Interim Release – PCC 2.5.744.0 – For Phantom Flex4K and CineStation IV Only
[This version of PCC was updated on 19 February 2014]
Download Release Notes here.
This release is for Phantom Flex4K and CineStation IV users only. The minimum firmware for the Flex4K is ph-flex4k-23.phfw (Firmware: 12397, FPGA: 954453, and Kernel: 563) and for the CineStation IV the minimum firmware is ph-csiv-23.phfw (Firmware: 12397, FPGA: 135, and Kernel: 563). You can check the version of firmware in your camera or CineStation IV by running the PCC application currently installed on your PC and clicking on the LIVE tab, selecting CAMERA INFO and looking for Firmware, FPGA, and Kernel.
Phantom Cine Viewer v2.3.741.0
Download the latest version of the Phantom Cine Viewer software. This file uploaded on 20 November 2013
This software allows you to view Phantom Cine files and can be used as a demo of standard Phantom software. You can convert cine files to other file formats. And, you can also do image processing.
*Please note* This software is only supported on the following operating systems:
If you need help with installation or have other questions about this software, please email questions to: email@example.com and we'll get back to you.